Poulan-pro PP125 Bedienungsanleitung PDF herunterladen (Seite 14)

14

INSPECT MUFFLER AND SPARK

ARRESTING SCREEN

WARNING: The muf fler on this prod-

uct contains chemicals known to the State of

California to cause cancer.

As your unit is used, carbon deposits build up

on the muffler and spark arresting screen and

must be removed to avoid creating a fire haz-

ard or affecting engine performance.

For normal homeowner use, the muffler and

spark arresting screen will not require any

service. After 50 hours of use, we recom-

mend that your muffler be serviced or re-

placed by an authorized service dealer.

REPLACE SPARK PLUG

Replace the spark plug each year to ensure

the engine starts easier and runs better . Set

spark plug gap at 0.025 inch (0.6 mm). Igni-

tion timing is fixed and nonadjustable.

NOTE: This spark ignitio n system complies

with the Canadian standard ICES--002.

1. Twist, then pull off spark plug boot.

2. Remove spark plug from cylinder and

discard.

3. Replace with Champion RCJ-6Y spark

plug and tighten securely with a 3/4 inch

(19 mm) socket wrench.

4. Reinstall the spark plug boot.

SERVICE AND ADJUSTMENTS

REPLACING TH E LINE

1. Press the tabs on the side of the trimmer

head and remove cover and spool.

Tab

Cover

Tap B u t to n

2. Remove any remaining line.

3. Clean dirt and debris from all parts. Re-

place spool if it is worn or damaged.

4. Replace with a pre-wound spool, or re-

place line using a 15 feet (4.5 meters)

length of 0.095 inch (2.4 mm) diameter

Poulan PRO brand line.

5. When installing new line on an existing

spool, hold the spool as shown in the il-

lustration below .

6. Bend the line at the midpoint and insert

the bend into the slot in the center rim of

the spool. Ensure line snaps into position

in the slot.

Slot

Spool

7. With your finger between the lines, wrap

the lines evenly and firmly around the

spool in a clockwise direction.

8. Position the lines in the guide slots.

Guide

Slot

Guide Slot

9. Insert the ends of the lines through exit

holes in the sides of the cover.

10. Place the spool in the cover.

Spool

Cover

11. Make sure the lines are not caught be-

tween the rim of the spool and the wall of

the cover .

12. Reinstall the spool and cover onto the

trimmer head. Push until cover snaps into

place.

REPLACING T HE CUTTING HEAD

1. Align hole in the dust cup with the hole in

the side of the gearbox by rotating the

dust cup.

2. Insert a smal l screwd ri ve r in to alig n e d

holes. This will keep the shaft from turning

while removing and installing trimmer head.

Screwdriver

3. While holding the screwdriver in position,

remove trimmer head by turning clockwise.

1 2 ... 9 10 11 12 13 14 15 16 17 18

Kommentare zu diesen Handbüchern

Keine Kommentare